As the new season approaches, it’s time to tackle a job that many carp anglers either look forward to—or try to avoid: re-spooling your reels. While it might not be the most thrilling task, doing it properly can make a huge difference to your performance on the bank. This guide walks you through an effective, no-nonsense method of re-spooling using one of the most trusted monofilament lines available—PB Control.
Many anglers underestimate just how critical a quality mainline is. Hooks, bait and rig mechanics get plenty of attention, but if your line fails, everything else is irrelevant. PB Control Mono stands out for its strength, suppleness, and casting performance. Whether you’re casting long range or battling through weed, this line has the reliability and feel that serious carp anglers demand.
Available in a range of breaking strains, PB Control offers flexibility without compromising on quality. For all-round balance between distance and durability, the 24lb version hits the sweet spot, while 28lb or even 30lb is ideal for short-range fishing in heavy weed or snaggy conditions.
There’s a lot of myth around line preparation—should it be soaked overnight, warmed, or treated? The truth is, with modern manufacturing processes, these steps are largely unnecessary. PB Control Mono doesn’t need an overnight bath. A quick 20-minute soak in a sink or margin is enough to add a touch of moisture, which helps it lay smoothly on the spool. It’s more about convenience than science.
One smart tip for consistency is to use cheap backing line to fill your reel to the lip once, then remove 250 yards of line using wrapping sticks. Mark that point. Every time you re-spool, you start from that mark, guaranteeing a perfect fill with no guesswork—no matter how many times you re-line.
To prevent twist, always make sure the line comes off the spool in a way that lets it feed straight through the butt ring and onto the reel. Place your reel on the rod, thread the line through the butt ring, and observe. If you see coils or twists, flip the spool over and try again. In nearly all cases, label side up will ensure the line flows correctly.
Some anglers overcomplicate tensioning with gloves, books, or pulley systems. All you need is a simple sock over your hand, pinching the line lightly between the blank and the sock. This gives you the right level of tension without damaging the line or your hands.
Overfilling your spool can lead to wind knots and tangles. Aim to stop filling just before the line reaches the angled lip (chamfer) of your spool. This allows the line to conical off cleanly during the cast, giving you smoother, more accurate distance.
Re-spooling doesn’t need to be complicated. With PB Control Mono, you get a line that’s not only tough and cast-friendly, but also dependable session after session. Whether you’re fishing tight to snags or launching leads to the horizon, this line won’t let you down. So, if you’re gearing up for the spring season, make re-spooling a priority—and make PB Control your go-to mainline.
No results found.
